Publicité
Les langues disponibles
Les langues disponibles
3. Place the fan blade onto the motor shaft by matching the slot with the shaft pin. Fix the blade by tightening
the blade fastening screw in a counter-clockwise direction. Check that the fan blade can rotate freely by
turning it with your hand.
4. Put the front guard against the rear guard and fix with the clamping ring. Make sure the clamping ring is set
properly at the rim of the fan guards. Tighten the screw on the clamping ring.
OPERATION
Connect the appliance to a suitable power source. Then press the control panel or the remote control to choose
your desired functions.
1. ON/off: Press "
normal / Timer: off / Swing: off
Press "
" again to turn off the appliance.
2. SPEED: Press "
"1": low wind; "2": Medium wind; "3": high wind
3. MODE: Press "
1) Normal: under this mode, you can press "
2) Natural: under this mode, the appliance will operate as follows:
5 seconds medium wind → 5 seconds low wind → 5 seconds medium wind → 5 seconds high wind → 5
seconds medium wind → 5 seconds low wind → stop 3 seconds ... (Repeating)
3) Sleeping: under this mode, the fan will operate as follows:
5 seconds medium wind → 10 seconds low wind → 5 seconds medium wind → 5 seconds low wind → 5
seconds medium wind → 10 seconds low wind → stop 3 seconds ... (Repeating)
Note: In natural mode or sleeping mode, the motor works with the preset speed. That is, the speed button
cannot control the speed under these two modes.
4. TIMER: Press "
elapsed, the fan will be off and under standby condition.
5. SWING: Press "
6. Tilting angles: By pushing the fan-guard, you can adjust the fan to the preferred elevation.
CLEANING
1.
Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable
from the socket.
2.
Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down
with a damp cloth and dry it carefully. Always take out the mains plug first.
3.
Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it occasionally
using a dry brush or vacuum cleaner.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50-60 Hz
Power consumption: 55W
" to turn the appliance on. It will work with the following presetting: Speed: low / Mode:
" to adjust the speed.
" to choose the mode functions from Normal →Natural → Sleeping → ... (Repeating).
" to set your desired working time from 1h →2h →3h ... →7h →off. When the set time has
" to control the oscillation function on or off.
" to choose speed Low /Mid /High.
- 5 -
Publicité
