THOMSON WT 1407 Manuel D'utilisation page 31

GB
Soak: When water reaches the level during the main wash cycle, your laundry will soak
for five minutes and then the motor will rotate for 30 seconds. This process will be repeated
four times.
NOTE:
- Soak cycle will run before prewash cycle if the prewash function is selected.
The prewash indicator
- Soak cycle will run before main wash cycle if the prewash function is not selected.
The main wash indicator
Speed wash: For washing in a shorter time with a washing outcome comparable to that of
the standard programme. With this function selected, the main wash time will be reduced
in the following two ways:
a) After heating, if the main wash time in the selected programme requires less than
20 minutes, the main wash time will only be 5 minutes.
b) After heating, if the main wash time in the selected programme requires more than
20 minutes, the main wash time will be reduced by 20 minutes.
Intensive: To increase the washing performance, washing time will be increased. It is reco
mmended to select this function when washing baby clothes or clothes worn by persons
with allergic skin.
ess iron: If this function is selected, neither drain nor spin will run after the final rinse.
L
To resume programme, press
the function will be deactivated and then the machine will continue to operate.
NOTE: Remove wrinkles from clothing using an iron.
Before you start the programme, you can select an additional option if you wish.
1.Repeatedly press Option to select the desired extra programme.
- The selected function icon will flash on the display.
2.To confirm, press
- The selected function icon will stop flashing, indicating the option function is activated.
To deactivate the function, press
from the display.
Refer to the following table to check the suitable options for each programme.
will flash on the display during soak cycle.
will flash on the display during soak cycle.
.If has not been pressed in the last 10 hours,
OK.
and the function icon will flash and then disappear
Option
31