Dymo LabelWriter 450 Duo Guide De Démarrage Rapide page 4

Connecting your LabelWriter Printer
Do not connect the printer to your computer until after the
software installation is complete.
To connect the power
Plug the power cord into the power adapter.
1
Plug the power adapter into the power connector on the back of
2
the printer.
Plug the other end of the power cord into a power outlet.
3
Plug the USB cable into the USB port on the back of the printer.
4
When the software is completely installed, connect the other end
5
of the USB cable into an available USB port on your computer.
If the printer is not in the printer list when the installation is
Mac OS
complete, refer to the ReadMe file for instructions on how to add
the printer.
Loading Labels
The LabelWriter Duo printer uses two types of labels: LW roll labels
(such as Address or Shipping labels) and D1 label cassettes.
To load a label roll
Place the label roll on the spindle so that the labels feed from underneath
1
and the left edge of the label roll is firmly against the side of the spool.
Press the spool guide tightly against the side of the label roll, leaving no
2
gap between the roll and the spool.
2
Power adapter
Power cord
USB
Power
Spool Spool
spindle guide