Hama LiberoBuds Mode D'emploi page 7

• Select Hama LiberoBuds and wait until the earphones are listed
as connected in the Bluetooth
voice says, 'Your headset has been connected'.
Note – Bluetooth
If your terminal device requests a password to establish the
connection, enter 0000.
Note
If pairing was successful, the status LEDs of the earphones (4)
slowly flash blue. A voice says, 'Your headset has been connected'.
• You can now use the earphones.
5.2. Automatic Bluetooth
(after successful pairing)
Note
• Make sure that your Bluetooth
and Bluetooth
• For more information, please refer to the operating instructions of
your terminal device.
• Remove the earphones from the charging box. A voice says, 'Power
on – Your headset is connected'.
• After the headset and terminal device have been paired, a
connection is established automatically.
• You can now use the earphones.
Note
• If pairing was successful, the status LEDs of the earphones
(4) slowly flash blue. A voice says, 'Your headset has been
connected'.
• It may be necessary to change the settings on your terminal
device to enable it to automatically connect to the paired
earphones.
Note - Connection impaired
After the headset and terminal device have been paired, a
connection is established automatically. If the Bluetooth
connection is not established automatically, check the following:
• Go to the Bluetooth
whether the LiberoBuds are connected. If not, repeat the steps
listed under 5.1 Bluetooth
• Check whether obstacles are impairing the range. If so, move the
devices closer together.
• The performance can also be affected by a weak battery.
6
®
password
®
connection
®
is activated.
®
settings on your terminal device and check
®
®
settings on your terminal device. A
-capable terminal device is on
®
pairing.
®