Hama LiberoBuds Mode D'emploi page 5

4. Getting Started
• The two earphones and the charging box are equipped with a
rechargeable battery. The batteries must be fully charged before
using the product for the first time.
• Ensure that the earphones are switched off before charging them.
• Begin charging by connecting the included USB charging cable to
the charging socket (9) as well as to the USB connection of a
PC/laptop. Alternatively, you can charge the charging box using a
suitable USB charger. Please refer to the operating instructions for
the USB charger used.
• Place the earphones in the charging box, making sure to match
them with their correct positions (refer to the L and R labelling on
the product).
• The status LEDs of the earphones (4) are constantly lit red
during charging.
• The charging indicator of the charging box (2) flashes blue.
• It can take up to 1 hour to fully charge the earphone batteries, up
to 2 hours to fully charge the battery of the charging box.
Warning
Do not use the earphones while they are charging.
• Once the earphones have been fully charged, the status LED (4)
lights up and then goes out. It takes about 1 hour to fully charge
the earphones.
• Once the charging box has been fully charged, the 4 LEDs of the
charging box (2) are lit blue. It takes about 2 hours to fully charge
the charging box.
• Disconnect all cable and mains connections after use.
Note
If you have not used the item for a few month, it may take 15-30
minutes for the status LED (2/4) to red when charging.
5. Operation
Switching the earphones on/off
• Turn On:
Make sure that both earphones are fully charged (status LED (4)
off). Remove the earphones from the charging cradle at the same
time. Both earphones switch on automatically and begin pairing. A
voice says, 'Power on – Pairing'.
• Turn Off:
With the earphones on, press and hold the Multifunction button
(5) on the left or right earphone for about 5 seconds until you hear
4