Interroll MultiControl AI Notice D'utilisation page 61

Fault
RollerDrive does not rotate
Version 2.7 (05/2021) UL
Translation of the original operating manual
Assistance in the event of faults
Possible cause
RollerDrive not or not correctly
connected or RollerDrive defective
Brake resistor overheating: The
application is recovering too much
energy or the power supply is too high
Remedy
Ensure that the power supply
¾
is within the specified voltage
range
Check the connections and
¾
correct them if necessary
Replace the RollerDrive if
¾
necessary
Allow the system to cool
¾
down
If necessary, reduce the
¾
ambient temperature
Ensure that the power supply
¾
is within the specified voltage
range
61 of 140