Interroll MultiControl AI Notice D'utilisation page 60

Assistance in the event of faults
Fault
Communication error
RollerDrive error
No power supply to motors
The MultiControl is not working
or not working properly
The MultiControl is defective or
damaged
60 of 140
Possible cause
Connection to PLC interrupted
Error signal from the RollerDrive
or RollerDrive not connected to the
activated motor output
No or insufficient power supply
Internal fuse has been triggered or is
defective
Remedy
Check the bus wiring
¾
Check the bus type
¾
Check the network address
¾
and bus name
Check the motor
¾
configuration
Ensure that all RollerDrives
¾
are connected correctly
Check for faults in
¾
accordance with the
RollerDrive operating manual
Check the power supply
¾
(emergency stop?)
Ensure that the power supply
¾
is within the specified voltage
range
Check the connections and
¾
correct them if necessary
Replace the MultiControl
¾
Version 2.7 (05/2021) UL
Translation of the original operating manual