Cleaning And Care - Eurotops BL08 Mode D'emploi

❐ Remove the power plug from the socket, if you are not using the device,
1. Place the base on a dry, level, solid, water and heat-resistant surface and insert the
mains plug in a properly installed socket.
2. Take the kettle off the base unit. Open it by pulling the grip on the lid.
3. Fill the kettle with drinking water. Make sure that the water level is between the MIN
and MAX marks. If there is not enough water in the kettle, the device will deactivate
before completing the boiling process; if it is fi lled past the MAX mark, water may
spray out during the boiling process.
4. Close the lid. Make sure that you only touch the grip on the lid when closing the it to
prevent scalding by accident when the device has been used recently.
5. Place the kettle on the base unit.
6. Set the On/Off switch of the kettle to position I (ON). The device will turn on and the
LED light will illuminate. The LED light changes from blue to red during use. You can
interrupt the boiling process at any time by setting the On/Off switch to position 0
(OFF).
7. The kettle automatically deactivates once the water has boiled. The On/Off switch
sets automatically to position 0 (OFF) and the LED light switches off.
8. Remove the power plug from the socket and take the kettle off of the base and ca-
refully pour the water into a suitable container. Keep the lid closed when pouring out
the water.
9. If not in use, the kettle may be stored on the base. However, be sure to pull the mains
plug out of the socket.
If you accidentally use the kettle without any water, the device switches off au-
tomatically. In this case, push the On/Off switch to position 0 (OFF) and let the
kettle cool off before using it again.

Cleaning and care

ATTENTION!
❐ Never submerge the device, the mains cable, and the plug in water or other liquids.
❐ When cleaning, do not use any aggressive, scouring or toxic cleaners.
❐ Prior to each cleaning, pull the plug out of the socket.
❐ Allow the device to cool off before cleaning.
• Wipe the device off from the outside with a clean, damp cloth.
• Keep the device in a ready-to-operate state. You should remove limescale from
water on a regular basis and according to the water quality in your region and the
frequency of use. Use a decalcifi er for this. Follow the instructions of the decalcifi er
when decalcifying the kettle.
08107_de-gb-fr-nl_V1.indb 15 08107_de-gb-fr-nl_V1.indb 15
15
06.02.2015 11:00:14 06.02.2015 11:00:14