Setting Up And Connecting The Device Properly; Proper Use - Eurotops BL08 Mode D'emploi

Setting up and connecting the device properly

❐ Only use the device in closed spaces.
❐ Always place the device on a dry, level, fi rm, water and heat resistant surface.
❐ Do not subject the device to extreme temperatures, severe changes in temperature,
direct sunlight or moisture.
❐ Maintain adequate distance to heat sources such as stoves or ovens to prevent
damage to the device.
❐ Only connect the device to a properly installed socket with protective earth contacts.
The socket must also be easily accessible after the device has been connected.
The mains voltage must correspond to the technical data of the device (see chapter
"Technical data"). Only use proper extension cords, whose technical data corres-
pond to those of the device.
❐ Ensure that the connected mains cord does not pose a tripping hazard. Do not allow
the cord to hang over the edge of a table or kitchen worktop. Someone could catch
him/herself and pull down the device.
❐ Lay the cable such that it is not crushed or creased and such that it does not come
into contact with hot surfaces.
❐ Keep sharp and pointy objects away from the cable.

Proper use

❐ Check the device for damages prior to each use. If the device, the cord or the plug
exhibit visible damages, the device may not be used. Do not use the device if it had
a malfunction or has fallen down.
❐ If the device, the cord or the plug is defective, do not attempt to repair it yourself.
In the event of damage, contact the customer service department. Repairs may be
executed by qualifi ed personnel only.
❐ Only use the enclosed accessories from the manufacturer.
❐ Only use the kettle in combination with the base unit supplied and vice versa.
❐ Do not allow the device to fall and do not subject it to strong percussions.
❐ Do not leave the device on when it is unattended.
❐ When fi lling, pouring out or cleaning the kettle, take it off the base.
❐ Do not overfi ll the kettle. Never fi ll it above the MAX mark.
❐ Do not operate the device without water or if the water level is below the MIN mark.
However, the device automatically deactivates itself if this should happen. In this
case, push the On/Off switch to the position 0 (OFF) and let the kettle cool off before
you fi ll in and boil cold water again.
❐ Each time before boiling, ensure that the lid is properly closed and that the On/Off
switch is not jammed. The device only switches off automatically, when the lid is
closed and the On/Off switch is not jammed.
❐ Do not move the device during the boiling process.
08107_de-gb-fr-nl_V1.indb 12 08107_de-gb-fr-nl_V1.indb 12
12
06.02.2015 11:00:14 06.02.2015 11:00:14