Unpacking The Desk; Precautions; Caution; Connecting To The Back Panel - ADB BOLERO Manuel D'instruction

BOLERO

Unpacking the desk

After removing the desk from it's box, check that the following items are included :
• 1 BOLERO desk
• 1 power supply cable (2 m)
• 1 XLR-M plug for data cable
• 1 user manual (this document)
If any of the previous items are missing contact your supplier immediately. Retain the
box and packing material for any future transportation or storage of the desk.

Precautions

WARNING
To prevent fire or shock hazard, do not
expose these units to rain or moisture.

Caution

Disconnect the mains plug from the supply socket when not in use.
Avoid using the desk under the following conditions :
• Extremely hot, cold or humid places,
Ambient temperature :
Storage
Maximum gradient
Humidity
• Dusty places,
Be careful of moisture condensation.
Avoid using the desk immetiately after moving from a cold place to a warm place or
soon after heating a room which was cold.
Handle the desk carefully.
• Do not place anything heavy on the desk.
• Do not place anything which could spill and cause problems on or near the desk.

Connecting to the back panel

The only connection required to operate the desk is for the power cable to be plugged
into the power socket on the back panel, and the power plug to be connected to a
suitable mains outlet. However if any output is needed then a suitable cable needs to
be linked from the DMX512/1990 output socket to a recommended DMX512/1990
controlled dimmer unit.
Page 6
Revision : 003
0 to 40 °C
- 10 to 50 °C
:
5 °C per hour
:
: 30 % to 70 % RH without condensation.
Lighting Technologies