On/Off Button; Direction Button; Mode Button - ADB BOLERO Manuel D'instruction

Lighting Technologies

ON/OFF Button

All the «ON/OFF» buttons on the desk have the same basic effect.
They remove the effect of their associated section from the output on the stage, whithout
effecting the processing of that section, i.e. in the Effect section if the «ON/OFF» button
is pressed then the sections effect on the stage output is lost but the chase sequence
will continue. A press of the «ON/OFF» button is confirmed by it's LED going out,
another press of the button will reverse this action. To confirm, when the LED is OFF
then the on/off is in operation, i.e. no output from that section will reach the stage. All
«ON/OFF» buttons act with a toggle action, i.e. one press for ON, the next press for
OFF, press again for ON...

Direction Button

This button (shown as two arrow heads) has two LED's associated with it. One indicates
a right to left (BACKWARDS) direction, the other a left to right (FORWARDS) direction.
Pressing the direction button will cause the current Effect to travel from left to right
(FORWARDS LED lit). Another press will cause the Effect to travel from right to left
(BACKWARDS LED lit). A further press will cause the Effect to «bounce», to travel
alternately backwards then forwards (both LED's are lit). Pressing the key will cycle
through these three options.

Mode Button

This button allows the selection of the required chase pattern.
Simply press the «MODE» button once and then the «FLASH» button corresponding to
the pattern required. On both the BOLERO 12 and BOLERO 24 «FLASH» buttons 1 to
12 select chase patterns 1 to 12. On the BOLERO 24 the additional «FLASH» buttons
are used to select patterns 13 to 24 on «FLASH» buttons 13 to 24 respectively.
Those patterns are shown opposite :
= Light ON
= Light OFF
BOLERO
Page 11
Revision : 003