Delivery - Unpacking; Generalities - Safety; Important Notice For Power Cables - ADB BOLERO Manuel D'instruction

BOLERO

Delivery - Unpacking

Upon delivery of your equipment, open the packaging carefully and examine the material.
If you observe any damage, contact the shipping company immediately, and have your
complaint duly recorded. You may rest assured that your equipment left the factory in
perfect condition.
Check whether what you have received is in conformity with the delivery notice, and
whether the notice is in conformity with your order.
In the event of any error, contact your shipper immediately to clarify the situation and
receive full satisfaction.
If you find nothing wrong, replace the material in the packing and store it in a warm
place, away from dust and humidity, while awaiting final installation.
Never leave the material on the worksite under any circumstance.

Generalities - Safety

The equipment is built in accordance with European safety standards and requires
imperatively a safety earth connection in compliance with local regulations.
To prevent any risk of electric shock, do not remove any cover or part of the enclosure.
Access to internal parts is not required for normal operation.
Refer servicing to skilled and trained service personnel exclusively.
Disconnect from the power supply prior to opening for inspection or service.
WARNING ! LETHAL VOLTAGES ARE PRESENT INSIDE
Connection to an inappropriate power source may irreversibly damage the equipment,
it is the user's responsibility to use the equipment for its intended purpose and to
check the equipment connected to it.
To obtain full benefits of the safety measures, the equipment shall be installed and
serviced by skilled and trained personnel exclusively.
Don't make any modification to the equipment.
ADB shall not accept any liability for material damages or injuries which may result from
unauthorised modifications.

Important Notice for Power Cables

Power supply cables and connectors are an important part of your equipment and
contribute to its safety.
• always use an isolator or main circuit-breaker, or main fuses to interrupt the link;
never pull on the cable
• do not damage the cable nor the connectors in any way, check them at each
installation or at regular intervals in a permanent installation
• do not tie together power supply cables and signal cables
Page 4
Revision : 003
Lighting Technologies