Table des Matières
Publicité
ERVICE AND MAINTENANCE
Before carrying out any work on the equipment disconnect the plug.
Use a damp cloth to clean the plastic parts. Do not use cleaning agents, solvents or sharp object.
Keep the surface area of the saw table free from contaminations with an appropriate service and maintenance
spray.
Should the motor's braking system not activate within 10 seconds, the parts of the worn air brake should be
replaced by an authorised service centre.
Keep the ventilation openings and the moveable parts free from trapped dust with a soft brush.
Oil all moveable metal parts rrgularly.
TROUBLE SHOOTING GUIDE
Before any maintenance:
Switch off appliance.
Pull out plug.
Warning
No internal parts of this machine are user serviceable. Any internal parts should only be serviced at an authorised
service centre.
TROUBLE SHOOTING GUIDE
PROBLEM
Motor is not running.
Motor runs on after being
switched off
Motor stops during use.
Scorch marks on work
piece.
GUARANTEE
Refer to the enclosed guarantee conditions for the terms and conditions of guarantee.
ENVIRONMENT
Should your machine need
replacement after extended
use, do not put it in the
domestic waste but
dispose of it in an
environmentally safe way.
POSSIBLE CAUSE
There is no power to the
machine
The automatic safety cut-
out has been tripped.
The mechanical motor
break is worn.
The automatic safety cut-
out has been tripped.
The motor temperature
sensor is defective.
Saw blade is blunt
Machine is being used
incorrectly.
REMEDY
Check electricity supply,
and any external safety
devices being used.
Wait 5-10 minutes and try
machine again.
A new motor break can be
fitted at an authorised
service centre.
Wait 5-10 minutes and try
machine again. (if the
safety cut out continues to
stop the machine, it may
be being overloaded.
Check that blade is sharp,
and that machine is being
used correctly).
A new sensor can be fitted
at an authorised service
centre.
Have blade
sharpened/replace blade.
Ensure that material is not
being fed to fast, and that
guards and guides are
correctly set.
2007
Publicité
Table des Matières
