Sony WEGA KV-AZ212 Mode D'emploi page 6

Setting up your TV ("Initial Setup") (continued)
d) If you wish to edit the channels, press
to change to edit mode.
Press b until the mode that you wish to edit
is highlighted: Label, Skip,
Then press
1) To label, press V or v to select the
alphanumeric characters for the label.
Then press
2) To skip the program number, press V or v to
select "On". Then press
You can skip this program number when
using PROG +/-.
3) To block unwanted program number,
press V or v to select . Then press
e) Repeat step b) to d) if you wish to change other
channels.
Press WEGA GATE to go to the next menu.
4
Press B or b to adjust the bars on the top
and bottom of the menu if they are
slanted, then press
If no adjustment is necessary, then press
5
To prevent this "Initial Setup" menu from
appearing again when you turn on the TV
by pressing !, press V or v to select "No",
then press
To allow this menu to appear again, select
"Yes", then press
Tip
• You can immediately go to the end of the "Initial Setup" menu by pressing WEGA GATE.
6
(block symbol).
.
.
.
.
.
.
Program Sorting/Edit
PROG
01
02
03
04
Edit mode
Select
Program Sorting/Edit
PROG
02
03
04
Edit mode
Select
.
Select
.
Select
Label Skip
Off
Off
Off
Off
Confirm Exit
Label Skip
01 Off
Off
Off
Off
Confirm Exit
Confirm Exit
Select Confirm End
Confirm