Listening To Files On A Usb Flash Drive (Mp3/Wma) - Teac AD-RW900 Mode D'emploi

Listening to Files on a USB Flash Drive (MP3/WMA)

CAUTION
Never turn the unit off or disconnect a USB flash drive when
it is being accessed, for example, during writing, playback,
recording or the erasure of files.
Doing so could damage the AD-RW900 and the connected USB
flash drive.
< This section uses MP3 file as an example to explain the operation
process; the same process also needs to be followed when WMA
file is used.
1
Press the SOURCE button repeatedly to select "USB".
< When a different source is selected, starting USB playback
automatically selects the USB mode.
2
Connect an external USB flash drive to the USB port of
this unit.
Reading the USB flash drive takes a few seconds.
< If no MP3 file is on the USB flash drive, "NO MUSIC FILE" is displayed.
3
Press the USB Play/Pause (t/J) button to start playback.
< When playback of all the files has finished, the unit stops
automatically.
< MP3 files that are not put in folders are automatically put in the
"ROOT" folder. Playback starts from the first file in the ROOT
folder.
< See page 50 for information about the playback order of MP3 files.
22
Pausing playback temporarily
Press the USB Play/Pause (t/J) button during playback to stop
playback at the current position.
To resume playback, press the USB Play/Pause (t/J) button again.
Stopping playback
Press the USB Stop (H) button to stop playback.
Search for a part of a file
During playback, hold down a USB Search (m or ,) button
to search for a part of a file. Pressing and holding a Search button
increases the search speed.
Release it when you find the beginning of the part that you want
to hear.
Hold down