Teac AD-RW900 Mode D'emploi page 11

AD-RW900 (back side)
Ampli er
REC
(OUT)
TAPE/MD/CD-R
After all connections are complete, connect the power
cord's plug to the AC wall socket.
< Read the instructions of each device that you intend to use
with this unit.
< Be sure to connect each plug securely. To avoid hum and
noise, do not bundle the connection cords.
A
LINE IN/OUT jacks
These jacks transmit an analog 2-channel audio signal. Connect
the components using the included RCA pin cables.
Be sure to connect:
White plug e White jack (L: left channel)
Red plug e Red jack
White (L)
Red (R)
B
PHONO jacks [PHONO]
Connect the turntable's RCA pin cable to the PHONO jacks.
Be sure to connect:
White plug e White jack (L: left channel)
Red plug e Red jack
< Moving Magnet (MM) cartridges can be used for this unit.
C
SIGNAL GND [SIGNAL GND]
Connect the ground lead of the turntable to this terminal.
< This is not a safety earth.
< If the turntable's ground lead is not connected to this terminal,
hum noise may be heard.
D
A B C
Turntable
PLAY
(IN)
(R: right channel)
White (L)
Red (R)
(R: right channel)
E
CD Player,
MD Deck, etc.
DIGITAL OUT
DIGITAL IN terminal [DIGITAL IN]
D
To record digital audio signals, connect this terminal to the digital
output terminal of a digital device such as a CD player with a
commercially available optical digital cable.
If the sampling frequency of the input digital signal is changed
while an optical digital cable is connected, it might not be
recognized correctly. ("OPTICAL UNLOCK" will appear on screen.)
If this occurs, disconnect the optical digital cable from the
connector once and reconnect it after changing the frequency.
Alternately, after changing the frequency, you can turn the power
off once and then turn it on again.
< When the sampling frequency of the input digital signal is 48 kHz,
some of the audio specification values might differ.
E
USB port (B-type) [USB]
Connect this to a computer USB port to convert sound from this
unit to a digital signal and output it to the computer.
F
AC Power Cord
After all other connections are complete, connect the plug to an
AC wall outlet.
If you do not use this unit for a long period of time, unplug
the power cord from the wall outlet.
Be sure to connect the power cord to an AC outlet that
supplies the correct voltage.
Hold the power plug when plugging it into an outlet or
unplugging it. Never pull or yank on the power cord.
F
Wall
socket
Computer
11