Programmed Playback (Disc/Usb/Sd) - Teac CR-H238i Mode D'emploi

Programmed Playback (disc/USB/SD)

Up to 30 tracks/files can be programmed in the desired
order.
1 Press the PROGRAM button in the stop mode.
P-01 T___
T013 42:38
2 Select a track/file using the Numeric buttons.
P-01 T007
< You can also use the Skip buttons (.//) to
select a track/file.
3 Press the ENTER button.
28
4 Repeat steps 2 and
files.
< If you make a mistake, press the CLEAR button. The last
input track/file number will be deleted.
< Up to 30 tracks/files can be programmed. If you
attempt to programme more than 30 tracks/files,
"P-FULL" appears on the display.
5 When programming has been finished, press the
PLAY/PAUSE button (y/J) to start programmed
playback.
< After playback of all the programmed tracks/files has
finished or you stop the programmed playback, you
can return to the programmed playback by pressing
the Play/Pause button (y/J).
< When the PROGRAM button is pressed in the stop
mode, the programmed contents will be cleared.
To check the programmed order
In the stop mode, press the ENTER button repeatedly.
The track number and program number will be shown
on the display.
3 to program more tracks/