Proper Use; Technical Data; Before Starting The Equipment - HERKULES SHZ 500-2 Mode D'emploi D'origine

Anleitung_SHZ_500_2_SPK7:_

4. Proper use

The cable hoist is designed for lifting and lowering
loads in enclosed areas commensurate with the
machineʼs capacity.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data

Be sure to observe the information specified in
the technical data.
The rated load does not depend on the winding
layers.
Voltage (V)
Rated current (A)
Power consumption (W)
Operating mode
Rated load (kg)
Lifting height (m)
Rated speed (m/min)
Diameter of steel cable (mm)
Tensile strength of the steel cable (N/mm²)
Insulation class
Protection class
Drive unit class
Net weight (kg)
Maximum number of windings:
Operating mode S3 – 25% - 10 minutes: S3 =
Intermittent mode without influencing the starting
process. This means that the maximum operating
period over a time of 10 minutes is 25% (2.5
minutes).
06.04.2010 8:32 Uhr Seite 11
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.

6. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating
plate are identical to the mains data.
Always pull out the power plug before making
adjustments to the equipment.
The cable hoist is not suitable for transporting
hot and/or molten masses and in addition it is not
suitable for use at low temperatures or in
aggressive atmospheres.
It is in mechanical group M1.
The service life of the cable hoist is
approximately 8000 cycles (excluding wearing
parts). When the hoist has completed 8000
cycles, all its mechanical parts must be checked
230 V ~ 50 Hz
and overhauled.
4,0
Read and absorb the operating instructions
before you use the cable hoist.
900
Ensure that the operator knows how the machine
S3 25% 10 min
works and how it should be operated.
250 / 500 The user should always operate as set out in the
operating instructions.
11,5 / 5,7
The cable hoist is not designed for continuous
8 / 4
operation. Its mode of operation is: Intermittent
mode without influencing the starting process.
4,2
The rated capacity of the machine does not vary
1770
due to the position of the load.
B
6.1 Unpacking
IP 54
After opening the packaging, inspect the frame, the
M1
steel cable, the hook and the electric control
16,5
mechanism for signs of possible transit damage.
4
6.2 Assembly (Fig. 5)
The cable hoist is fitted with two fastening bars (1)
with which it has to be fastened to a rectangular
tube. The dimensions of the arm must conform with
the size of the fastening bars (1) and must be
capable of supporting twice the rated load. We
recommend that you seek advice from a qualified
technician.
GB
11