Mounting And Operation; Working Advice - Bosch GBL 860 Professional Notice Originale

OBJ_BUCH-2692-003.book Page 11 Thursday, October 13, 2016 2:23 PM
Typically the A-weighted noise levels of the product are:
Sound pressure level 81 dB(A); sound power level
100 dB(A). Uncertainty K =1.0 dB.
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 50636-2-100:
2 2
a =0.46 m/s , K = 1.5 m/s .
h

Mounting and Operation

The numbering of the figures refer to the illustrations of the
machine on the graphics page.
Action
Delivery Scope
Tube Assembly
Inserting the adapter into the garden tool 3
Starting
Stopping

Working Advice

Maintenance and Cleaning
Working Advice
Product transportation
Always transport tool without the battery adapter fitted to the
product.
Make sure the product is properly secured to prevent turno-
ver and damage to the garden tool.
Before starting the tool
Before using; check that your garden tool is properly assem-
bled and in good condition.
Inspect all guards for damage. Do not use if the guards are
damaged in any way to reduce the risk of personal injury. Con-
sult your Bosch service centre for repairs.
Check to see if the inlet guard is free from debris.
Check to see if the fan is not obstructed/blocked by any de-
bris. If it is blocked, only clear the blockage with the battery
adapter removed from the product. Return product to service
centre if this cannot be done safely.
Troubleshooting
Problem Possible Cause
Machine does not start The switch was not turned off
after turning off properly before the battery adapter
was inserted
Bosch Power Tools
Check the battery adapter compartment for debris and dam-
age, debris must be cleared. If damaged do not use the prod-
uct, return it to a Bosch service centre for repair/replace-
ment.
Check the battery adapter for damage.
Check trigger movement is free, not obstructed and returns
back to its off position.
Make sure the nozzle is properly fitted to the product.
Battery adapter is fitted properly to the product and is locked
into position.
Make sure the handle is clean and dry from any fluids/oil for
Figure Page
safe control of the garden tool.
1 75
During operation
2 75
Always hold the garden tool firmly in your hand.
76
Walk slowly forwards as you work, observe the nozzle outlet
at all times.
4 76
To reduce the risk of injury, operate the unit only with a prop-
4 76
erly mounted blower tube.
The flat nozzle produces a broad and powerful airstream at
5 77
ground level. It can be aimed and controlled very accurately.
6 77
This garden tool is design to be used by one person only. Do
not allow other persons in the work area.
Do not direct the airflow towards bystanders or animals since
the airflow can blow small objects at great speeds.
This product is fitted with thermal protection for safety – if
the product overheats the power output will be automatically
reduced to prevent damage to the tool. If the overheating still
occurs, the product will switch off and will not start again until
a safe temperature is reached. Refer to the battery and bat-
tery carrier manual for troubleshooting.
To reduce the risk of accidents, take a break in good time to
avoid tiredness or exhaustion.
If there is a noticeable change in running behaviour (e. g. high-
er vibration), stop work and rectify the cause of the problem
– refer to troubleshooting
After operation
Always make sure the product is turned off and remove the
battery adapter from the garden tool.
Corrective Action
Turn the switch off, remove the battery adapter
from the product for 5 seconds. Re-insert the
battery adapter into the product.
English | 11
1 609 92A 3F2 | (13.10.16)