ECOVACS WINBOT 880 Manuel D'instructions page 12

3. Operating WINBOT
c. Spot Cleaning Mode
This mode can be used for an area with concentrated dirt and dust.
2
Pause
Note: The Direction Control Buttons on the Remote Control cannot be
used until WINBOT is paused.
12
EN
OR
3
Replace the Cleaning Pad
Pause WINBOT and press on WINBOT for 5 seconds to take WINBOT
down. Remove the dirty Cleaning Pad from the WINBOT and place a
clean new one on it.
The gray microfiber side faces out. Make sure the side with
Note:
attached to WINBOT Cleaning Pad Plate with the same
Make sure the Cleaning Pad correctly attached. Do not cover the
Squeegee or Edge Detection Sensors.
is
.