Husqvarna K1270 II R Manuel D'utilisation page 13

piston and cylinder. For recommended spark plug refer
Technical data on page 21 .
to
Examine the spark plug if the product is low on power,
does not start easily or if it operates unsatisfactorily at
idle speed.
1. Loosen the 3 screws on the air filter cover and
remove the air filter cover.
2. Make sure that the spark plug cap and ignition cable
are not damaged to prevent the risk of electrical
shock.
3. Clean the spark plug if it is dirty.
4. Make sure that the electrode gap is 0.5 mm.
1390 - 001 - 10.01.2020
5. If it is necessary, replace the spark plug.
To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
Starter housing
WARNING: Always be careful and always
use eye protection when you replace the
recoil spring or the starter rope. There is
tension in the recoil spring when it is wound
in the starter housing. The recoil spring can
eject and cause injury.
To remove the starter housing
1. Loosen the 4 screws on the starter housing.
2. Remove the starter housing.
13