Connecting The Controller - Dometic Waeco PerfectView VS400 Instructions De Montage Et De Service

Connecting electrical power to the video splitter
 When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 9, page 6).
 Protect every through-hole made in the bodywork against water penetration, e.g. by
using a cable with a sealant and by spraying the cable and the cable sleeve with seal-
ant.
NOTE
I
Only start sealing through-holes when you have completed all installation work
on the camera and have laid the required cable lengths.
7.2

Connecting the controller

➤ Connect this connection (fig. 2 1, page 3) to the controller.
➤ Connect this connection (fig. 2 2, page 3) to the monitor.
➤ Connect the cable set (fig. 1 3, page 3) to the plug of this connection (fig. 2 3,
page 3).
7.3 Connecting the cable set
The cable set features the following connections:
No. in
fig. 0, page 6
1
2
3
4
5
6
7
➤ Connect the camera connections (fig. 0 1, page 6) to the cameras.
➤ Connect the red cable (fig. 0 2, page 6) to the positive wire (+) of the vehicle.
➤ Connect the black cable (fig. 0 3, page 6) to the earth wire (–) or to earth (bodywork).
➤ Connect the green cable (fig. 0 4, page 6) to the positive wire (+) of the reversing light
(camera 1).
➤ Connect the white cable (fig. 0 5, page 6) to the control signal for camera 2.
➤ Connect the blue cable (fig. 0 6, page 6) to the control signal for camera 3.
➤ Connect the brown cable (fig. 0 7, page 6) to the control signal for camera 4.
28
Explanation
Connections for camera 1 – 4, 6-pin, protected from jets of water
12 V connection +, red
Earth connection –, black
Control input for reversing light (camera 1), green
Control input for camera 2, white
Control input for camera 3, blue
Control input for camera 4, brown
VS400
EN