Installing The Operating Unit; Installing The Controller; Connecting Electrical Power To The Video Splitter - Dometic Waeco PerfectView VS400 Instructions De Montage Et De Service

VS400
6.2

Installing the operating unit

NOTE
I
Make sure the adhesive surfaces (surface and bottom of the unit) are clean, dry
and free of grease.
Proceed as follows:
➤ Glue the velcro strip to the bottom of the operating unit.
➤ Glue the matching velcro strip to a suitable position in the vehicle (fig. 6, page 5).
➤ Affix the operating unit.
6.3

Installing the controller

Proceed as follows:
➤ Hold the controller at its installation location and mark the four points for the drill holes.
➤ Drill the holes, with a Ø of 3.5 mm, at each of the markings.
➤ Screw the controller in place using the 4 mm self-tapping screws (fig. 7, page 5).
7

Connecting electrical power to the video splitter

7.1 General notes on laying cables
NOTE
I
 As far as possible, use original ducts for laying the cables, or other suitable
options such as panelling edges, ventilation grilles or dummy plugs. If no
openings are available, you must drill holes for the cables. Check beforehand
that there is sufficient space on the other side for the drill head to emerge.
 Cables and connections that are not properly installed will cause malfunctions
or damage to components. Correct installation of cables and connections en-
sures lasting and trouble-free operation of the retrofitted components.
Therefore, please observe the following instructions:
 Wherever possible, lay cables inside the vehicle, as they are better protected there
than outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use
additional cable ties, insulating tape etc.).
 To prevent damage to the cables when laying them, ensure that they are far enough
away from hot or moving vehicle components (exhaust pipes, drive shafts, light sys-
tems, fans, heaters, etc.).
 Screw on the plug connections for the connecting cables to protect them against water
penetration (fig. 8, page 6).
EN
Connecting electrical power to the video splitter
27