Areas Of Application; Installation; Fitting The A 812 - Miele A 812 Mode D'emploi

Fitting the A 812

Installation

The A 812 adapter is designed for use on injector manifolds with silic-
one adapters.
Remove a nozzle and the silicone adapter from the injector mani-

fold.
Place the sealing ring around the injector port that is now free.

Insert the threaded bush into the injector port.

Secure the threaded bush with the clamp. The clamp must reach

around the injector manifold.
Screw the bottom part of the adapter  into the threaded bush.

The wash water used for reprocessing narrow lumen instruments
such as transmission instruments needs to be filtered.
To do this, insert an FP 20 filter plate  into the bottom part.

Insert the silicone adapter  into the bottom part.

Screw the top part  and bottom part  together.

You can then connect the nozzles, e.g. nozzles with A 815 silicone
hoses, or other irrigation sleeves and rinse fittings of your choice to
the adapter.
To fit the A 812 on an injector manifold with a screw thread, you
have to replace the clamp, sealing ring, and threaded bush with the
A 801 threaded adapter.
en - Areas of application
33