Care And Cleaning; Service And Customer Care - Kenwood JKP200 Série Mode D'emploi

4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
If you experience problems
G
with your kettle switching on
and off during use or
switching off before boiling,
check that the flat element is
free from scale - see
"descaling".
Your kettle is fitted with a filter to
G
hold back limescale particles.
If you find drops of water under your
G
kettle, don't worry - it is just
condensation.
boil-dry protection
If you switch on with too little water,
G
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.

care and cleaning

Before cleaning, unplug your kettle
G
and let it cool down.
the outside and powerbase
Wipe with a damp cloth, then dry.
G
Do not use abrasives - they will
scratch the plastic surfaces.
the inside
Even though your kettle comes with
G
a filter, you still need to clean the
inside (and the filter) regularly.
the filter
1 Open the lid by pulling the lid release
catch back. Then pull the lid
back.
2 Gently lift out the filter
3 either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 To re-fit the filter, slide it in until
secure .
5 Close and lock the lid by pressing
the lid down.
G
Please note: Failure to descale your
kettle may invalidate your guarantee.
G
G
G
service and customer
care
G
G
G
.
G
G
3
descaling
Regular descaling of the flat element
will improve the performance of your
kettle. If the kettle is not descaled
regularly the build up of limescale
may result in the following:
problems may be experienced
G
with the kettle switching on and
off during use or switching off
before boiling.
the kettle may take longer to boil.
G
the flat element may be damaged.
G
When limescale starts to build up on
the heating element, buy a suitable
descaler and descale your kettle.
After descaling, boil with fresh water
several times and discard. Clean any
descaler off the kettle - it can
damage the parts.
Some regions of the country have
chalky water. This makes boiled
water look cloudy and leaves a
deposit on the side of the kettle. This
is normal but can be removed with
regular cleaning.
Alternatively, to reduce limescale
build up, use filtered water to fill your
kettle.
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
using your appliance
servicing or repairs
Contact the shop where you bought
your appliance.
Designed and engineered by
Kenwood in the UK.
Made in China.