Velleman CAMIP5 Notice D'emploi page 16

Alarm Service Settings
• Check the 'Motion Detect Armed' checkbox to enable motion detection. This also allows mails to
be sent out (see Mail Service Settings) and image upload to an FTP server (see FTP Service
Settings).
Note: when the camera is in auto tilt/auto pan mode (see For Operator layout), motion
detection and external alarm input are disabled!
• The motion detect sensibility van be set between 1 and 10, with 10 being most sensitive.
• Check the 'Alarm Input Armed' checkbox when an external alarm sensor is connected to the
alarm input connectors [11.3] and [11.4].
• Check the 'IO Linkage on Alarm' checkbox to activate the alarm output connectors [11.1] and
[11.2]. When an external alarm output device (e.g. a buzzer, flash light...) is connected it will be
activated whenever an alarm condition is present.
• Check the 'Send Mail on alarm' checkbox to send a mail when an alarm is detected. Make sure to
fill out all fields on the 'Mail Service Settings' page (see above).
• Check the 'Upload Image on alarm' checkbox to upload images to an FTP server when an alarm is
detected. Make sure to fill out all fields on the 'FTP Service Settings' page (see above). When this
option is checked, you can also set the upload interval (in seconds).
• Check the 'Scheduler' checkbox to open the day schedule. Click on the schedule to set the time
during which alarm service must be enabled. Horizontal axis = hours, divided per 15 minutes and
Vertical axis = day of the week.
Upgrade Device Firmware
• Only use this option when problems with the current version are noticed. Do not upgrade if the
camera works fine.
• Caution: when the upgrade process is interrupted or a wrong version is installed the camera
might not work anymore.
• When clicking on Upgrade Device Firmware or Embedded Web UI (User Interface), a brower
window is opened. Locate and select the new firmware/web UI.
27.10.2010
CAMIP5
16
Rev.01
©Velleman nv