Velleman CAMIP5 Notice D'emploi page 14

DDNS Service Settings
• Obtain a domain name from a supported DDNS provider (see image above) and enter the data in
the appropriate fields.
Mail Service Settings
Note: these settings only take effect when the option 'Send Mail on Alarm' is checked in the 'Alarm
Service Settings' menu (see below).
• Fill in a senders e-mail address in the 'Sender' field. This is the mailbox from which the mails will
be sent.
• Fill in up to 4 receivers mail addresses. When an alarm condition occurs, mail is sent out to these
addresses.
• Fill out all SMTP data related to the senders' mail box. When authentication for the mailbox is
required, check the checkbox and enter user name and password in the appropriate fields.
• When the 'Report Internet IP by Mail' is checked, a mail is sent whenever a camera comes online
(e.g. after reboot) or a change in IP address occurred. Make sure the port is correctly mapped to
the router.
• Press 'Submit' to store the data before performing a 'mail test'. Following error messages may
pop-up:
• Can not connect to the server
Check network cabling and settings.
• Network error. Please try later.
Check network cabling and settings.
• Server error.
Check the server.
27.10.2010
CAMIP5
14
Rev.01
©Velleman nv