Carat CARACOUP Série Mode D'emploi page 22

GB
the working table (see picture 11);
d- the cutting adjustment with the specially
provided indicator and ruler placed on the slide
rail.
13
In order to carry out special working it is possible to
set out any cutting inclination ranging from 0° to 45°
as marked on the machine side (See picture 14).
14
CAUTION!
BEFORE ANY CUTTING MAKE SURE THAT
THE TILE TO BE CUT IS PROPERLY LEANED
AGAINST THE TILE-STOPPER.
10. Residual Risks
During the design phase, CARAT paid particular
attention to the aspects that may generate risks for
the safety and health of operators.
In spite of this, there are still some potential risks,
which are described below:
CAUTION!
• Danger of presence of electric current.
The machine has an internal electric system:
CONNECT THE MACHINE TO A SYSTEM
WITH DIFFERENTIAL PROTECTION AND
EFFECTIVE EARTH WIRE.
• Danger of prolonged exposure to noise:
The continuative use of the machine causes an
exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR
DEFENDERS.
• Danger of exposure to fragments of materials.
OPERATORS MUST WEAR PROTECTIVE
GOGGLES.
• Danger of accidental contact with the moving
tool.
OPERATORS
PROTECTIVE GLOVES
ALWAYS STAY IN THE WORKING POSITION
(Pos. 1 picture 10) DURING THE MACHINE
OPERATION PHASES:
- During material loading;
- During material cutting;
- During the cutting tool deceleration following the
machine stop.
11. Maintenance
CAUTION!
BEFORE PERFORMING ANY OPERATION OR
ADJUSTMENT, DISCONNECT THE MACHINE
FROM THE SUPPLY MAINS.
CLEANING
CAUTION!
DO NOT WASH THE MACHINE WITH HIGH
PRESSURE WATER JETS
It is extremely easy to clean the CARACOUP
machine by loosening the side knobs and
dismantling the working table.
Through the side tap remove any working residual
22
CAUTION!
CAUTION!
CAUTION!
MUST WEAR HEAVY