Carat CARACOUP Série Mode D'emploi page 18

GB
6. Technical data
Voltage:
Power absorbed:
Admissible working conditions:
INTERMITTENT S3 SERVICE
30s
30s
Rotation speed:
Condenser:
Thermal circuit breaker:
IP Degree:
BUK2650000
Weight
34 Kg
Tank capacity
25Lt
RECOMMENDED USE:
CUTTING TOOL
DIAMOND BLADE WET CUTTING
CONTINUOUS CROWN:
ceramic, single-fired ceramic, cotto and marble
(max. thickness 20 mm.)
THE TOOL / MATERIAL TO BE CUT MATCHES
ARE PURELY INDICATIVE.
ALWAYS FOLLOW
INDICATIONS PROVIDED BY THE CUTTING
TOOL MANUFACTURER
APPLICATION.
BUK2650000
Max tool diameter:
Centre hole:
Maximum cutting depth:
90° cut:
Maximum cutting length
600 mm
Water recirculation pump:
Machine dimensions:
BUK2650000
BUK2900000
230V 50Hz~
1000 W
under load running
repose
2800 min-1
14 µF
170°C
BUK2900000
39 Kg
(min/max)
35Lt
THE INTENDED USE
BEFORE ANY
BUK2900000
Ø200 mm
25,4 mm
40 mm
900mm
S0 230V 50/60Hz
440 x 1160 x h. 1250 mm
440 x 1460 x h. 1250 mm
7. Installation
TRANSPORT
The CARACOUP machine is easy to carry by using
the specially provided side handles.
Before carrying the machine make sure that:
• the motor carriage is locked in place with the two
cutting adjustment knobs on the slide rail;
• the motor carriage is completely lowered and
locked with the locking lever;
• the machine is in the 45° (jolly) position and
the inclination adjustment knobs are properly
54
tightened;
• the tube-holder rod is out of its housing.
• the feet are closed with the leg locking pin
(see picture 3).
3
POSITIONING
Place the machine on a stabile surface.
To place the machine in working position, proceed
as follows:
CAUTION!
ASSICURARSI
RISULTI BLOCCATA IN POSIZIONE RIBASSATA
MEDIANTE LA LEVA A RIPRESA POSTA SUL
LATO MOTORE.
MAKE SURE THAT THE SLIDING CARRIAGE
IS LOCKED BY MEANS OF THE CARRIAGE
LOCKING STOPPER.
18
CHE LA TESTA MOTORE