Carat CARACOUP Série Mode D'emploi page 20

GB
CONNECTING TO POWER SUPPLY
CAUTION!
The machine is to be connected to the power
supply by a residual current circuit breaker (RCCB)
with the following characteristics:
RCCB
Transformer
N.B. To ensure correct functioning, periodically
check the efficiency of RCCBs by pressing the
push-button on the front of the device.
- Make sure that the section of the power supply
cable cores has been measured according to
the starting current and its length.
For cables up to 50 m long, a section of 2.5 mm
is enough.
- Before connecting the machine to the power
socket, check that the power supply voltage
corresponds to that shown on the plate on the
machine.
- The machine must be connected to an effective
earth wire.
In case of doubt, do not connect the machine.
BLADE ASSEMBLY / DISASSEMBLY
Before performing any operation or adjustment,
disconnect the machine from the supply mains.
Loosen both nuts located on the blade cover guard
and remove it.
Remove the blade fixing nut using the 19 mm
spanner and the 5 mm Allen wrench.
CAUTION!
THE BLADE FIXING NUT HAS A LEFT-HAND
THREAD.
After dismantling the blade, clean the blade flanges
carefully and check them for wear.
Grease any surface with fine oil and install the new
blade. Check for correct direction of rotation as
clearly indicated on the tool.
In 6 A Id 30 mA
230 V 50 Hz 1500 W
Transformer
2
20
8
CONTROL DEVICES
CAUTION!
The CARACOUP machine is equipped with a
control board made up of:
1) START BUTTON (GREEN COLOUR):
Press the button fully to activate machine
starting.
2) REGULAR STOP BUTTON:
Press the button fully to activate machine
stop.
3) DEVICE FOR DISCONNECTION FROM THE
MAINS (PLUG):
Machine power supply point.
During the maintenance phases, take out the
device plug in order to disconnect the machine
from the mains.
9