Dometic MC 402 Mode D'emploi page 17

MC402
Pin assignment see fig. 9 A+B, page 7:
Label
Power and voltage connector
ACC
GND
B+
KEY A
KEY B
KEY GND
BRAKE
REVERSE
Loudspeaker connection
– rear right (+)
– front right (+)
– front left (+)
– rear left (+)
– rear right (–)
– front right (–)
– front left (–)
– rear left (–)
To perform the installation and the electrical connection, proceed as follows:
➤ Disconnect the negative terminal of the battery.
➤ Remove any existing audio system.
➤ Install the 2 DIN installation sleeve (fig. 4, page 4).
➤ Bend the retaining tabs up, down and out at the sides in order to fix the housing
securely in the centre console (fig. 5, page 4).
➤ Attach the fastening brackets to the device with the fastening screws provided
(M5 X 6)(fig. 6, page 5).
➤ Connect the device to the electrical system in accordance with the circuit
diagram (fig. 9, page 7).
EN
Description
Ignition switching plus (terminal 15)
Earth (terminal 31)
+12 V battery
No function assigned
No function assigned
No function assigned
Handbrake switch
Reversing light
Installing the moniceiver
17