Installing The Moniceiver - Dometic MC 402 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
MC402
7

Installing the moniceiver

A
NOTICE! Beware of damage!
Before installing the monoceiver, remove the two screws used to
protect it during transport so that the DVD player can function.
7.1
Notes on the electrical connection
Please observe the following instructions relating to the electrical connection:
• This device is intended for use only in vehicles with 12 Vg and negative earth.
Ensure that the vehicle has the required 12 V voltage before installing the device.
If no voltage of 12 Vg is available, then a voltage converter must be used.
• If the ignition socket of your vehicle does not have an ACC position (starter
battery), install a switch between the ACC cable and the power supply.
• If you have put in a new fuse, but faults still occur, then approach the
manufacturers (see addresses on back), the manufacturers' customer service
department or a similarly qualified individual.
• Ensure that all electrical connections and the loudspeaker cables are well
insulated in order to avoid short circuits.
• Ensure that the screws for protecting the device during transport (fig. 6 1
page 5) are removed from the upper side of the device prior to installation.
7.2
Installing and connecting the moniceiver
A
NOTICE! Beware of damage!
• When drilling holes, check beforehand that there is sufficient space
on the other side for the drill head to come out.
• Cables and connections that are not properly installed will cause
malfunctions or damage to components. Correct installation of
cables and connections ensures lasting and trouble-free operation of
the retrofitted components.
Observe the following installation instructions:
• When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3, page 3).
• Attach the cables securely in the vehicles to prevent tripping hazards. Use e.g.
cable binder, insulating tape or adhesive for this.
EN
Installing the moniceiver
15

Publicité

Table des Matières
loading

Table des Matières