Operating The Device Safely - Dometic MC 402 Mode D'emploi

MC402
• Secure any parts of the system covered by the bodywork in such a
manner that they cannot be come loose or damage other parts and
cables or impair vehicle functions (steering, pedals, etc).
• Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may
only be performed by qualified specialists.
A
NOTICE!
• To prevent damage when drilling, make sure there is sufficient space
on the other side for the drill head to come out.
• Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
A
NOTICE!
• When testing the voltage in electrical cables, only use a diode test
lamp or a voltmeter.
Test lamps with an illuminant take up voltages which are too high and
which can damage the vehicle's electronic system.
• When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
• Insulate all connections.
• Secure the cables against mechanical wear with cable binders or insu-
lating tape, for example to existing cables.
2.2

Operating the device safely

!
WARNING!
• Never play videos while you are driving to avoid dangerous situations
in road traffic. Adhere to the country-specific laws and regulations.
• Only use the device in its function as a reversing video system while
driving. The driver must not look at the monitor under any circum-
stances while driving along. This could distract the driver and lead to
a serious accident.
• Adjust the volume of the device so that noise from traffic, particularly
horns and beeps, are still able to be heard.
EN
Safety information
11