DeLonghi DSM800 Série Mode D'emploi page 9

Assembling Your Pasta Maker
1) Optional: For easier pasta making, warm the
pasta maker parts in hot water, and then dry
thoroughly.
2) Fit the scroll (4) inside the
body (5). Then fit a screen
(3) by putting the notches
over the pins. Figure 1. The
screens are numbered:
1: Spaghetti
2: Macaroni
3: Rigatoni
4: Tagliatelle
5: Lasagne
6: Large Macaroni
Operating Your Pasta Maker
1) Make pasta dough according to the directions on
your dough recipe.
2) Remove the low-speed
outlet cover by sliding the
catch and then pull. Figure
2.
3) Hold the catch back and
insert the pasta maker, with
the feed tube facing you.
Turn it from side-to-side until
it locks into place.
4) Tighten the ring nut and then switch the stand
mixer to speed 3.
5) Drop small pieces of the mix at a time into the feed
tube (6). Figure 3. Allow the scroll to clear before
continuing. You can push them down gently using
the spanner handle. Do not use anything else or
push too hard. Your pasta could break.
Figure 1
Figure 2