DeLonghi DSM800 Série Mode D'emploi page 15

Operating Your Fruit and Vegetable Strainer
(continued)
5) Insert the paddle (1) and turn it until it stops. Then
push into mixer head. Figure 1.
6) To remove it, turn it back in the opposite direction.
7) Lower the mixer head. The paddle blades should
bend slightly against the strainer.
8) Note: If you need to adjust
the height, see the "Adjust
ing the Paddle Height"
section.
9) Allow cooked food to cool.
10) Switch the stand mixer to
"min". Clear the
screen between batches.
11) Keep hands out of bowl and away from the paddle
during operation.
12) Increase the speed slowly to 1 or 2, but reduce
the speed if the ingredients start to splatter.
Adjusting the Paddle Height
1) Unplug the stand mixer and raise the mixer head.
2) Insert the paddle. Hold the paddle, and then loosen
the nut.
3) Lower the mixer head. Adjust the height by turning
the paddle. The paddle blades should bend slightly
against the strainer.
4) Raise the head, hold the paddle and then tighten
the nut.
Care and Cleaning for Your Fruit and
Vegetable Strainer
1) Switch the stand mixer "off" before removing the
paddle. Wash bowl, paddle and screen by hand
with warm water and mild detergent, and then
rinse and dry thoroughly.
Figure 1