DeLonghi DSM800 Série Mode D'emploi page 17

Assembling Your Juice Extractor
1) Position the bowl onto the stand mixer by aligning
the tabs with the grooves in the base
(10).
2) Insert the strainer by aligning the
tabs.
3) Using the top of the stomper, screw
the grater plate on counterclock-
wise.
4) Fit the lid, and then swing the clip up
and click it shut.
5) Slide the pulp shield (4) on. Re-
move the high-speed outlet cover.
Attach the juice extractor, and turn it until it locks
into place. Figure 1.
6) Place a container under the spout.
Preparing Food for Your Juice Extractor
1) Remove pits (Ex. plums, peaches and cherries)
2) Remove tough skins (Ex. melons, pineapples,
cucumbers and potatoes.)
3) Soft-skinned and other food just need washing
(Ex. apples, grapes, pears, strawberries, cab-
bage, carrots, celery, lettuce, parsley, etc.)
4) Cut the food to fit the feed tube.
5) Slide the pulp shield on. Remove the high-speed
outlet cover.
6) Switch the stand mixer to speed 1 and push the
food down with the stomper.
Care and Cleaning for Your Juice Extractor
1) Dismantle before cleaning according to the
directions under "Dismantle the Juice Extractor".
2) Do not wash any parts in your dishwasher.
Wash parts by hand with mild detergent and
warm water, and then rinse and dry thoroughly.
Figure 1