Table des Matières
Publicité
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate @ 44 PSI
Hole size in mounting surface
Max. depth of mounting surface
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
•
For best results, Hansgrohe recommends that
this unit be installed by a licensed, profes-
sional plumber.
•
Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
•
The mounting surface must be completed and
made watertight before installing this valve.
•
This valve requires ½" hot and cold supply
lines (not included).
•
For best service of the thermostatic mixing
valve, the incoming hot and cold water must
be at the same pressure.
•
This valve is for a two-function installation.
Both outlets must be plumbed. Do not plug
either outlet. For a one-function installation,
see the special piping instructions.
•
To prevent scald injury, the maximum output
temperature of the shower valve must be
no higher than 10°F. In Massachusetts,
the maximum output temperature can be no
higher than 11° F.
•
Keep this booklet and the receipt (or other
proof of date and place of purchase) for
this product in a safe place. The receipt is
required should it be necessary to request
warranty parts.
15 - 75 PSI
145 PSI
10° - 140° F*
176°F*
8 GPM
⅜"
1⅜"
3
Publicité
Table des Matières
