Handling Guideline Of Discs And Player - Pioneer SuperTuner IIID DEH-P7100BT Mode D'emploi

Appendix
Additional Information
iTunes tagging
Message Cause
iPod full. Tags
Memory used for
not trans-
tag information
ferred.
on the iPod is
full.
Memory full.
This unit's flash
Tags not memory used for
stored. temporary sto-
rage area is full.
Tag trans- This unit's tag in-
ferred failed.
formation cannot
transfer to the
iPod.
Tag store
Tag information
failed.
cannot be stored
in this unit.
ERROR-8D Built-in FLASH
ROM encoun-
tered an error
Bluetooth audio/telephone
Message Cause
ERROR-10
Power failure of
the Bluetooth
module of this
unit
72
En
Action
Sync the iPod with
iTunes and clean
up the tagged play-
list.
Connect the iPod
to this unit and
transfer this unit's
tag information to
the iPod.
Check the iPod
and try again.
Try again.
Turn the ignition
OFF and ON.
Action
Turn the ignition
switch OFF and
then to ACC or ON.
If the error mes-
sage is displayed
again after the ac-
tion, please con-
tact your dealer or
an authorized
Pioneer Service
Station.
Handling guideline of discs
and player
! Use only discs featuring either of following
two logos.
! Use only conventional, fully circular discs.
Do not use shaped discs.
! Use 12-cm or 8-cm CD. Do not use an
adapter when playing 8-cm CDs.
! Do not insert anything other than a CD into
the CD loading slot.
! Do not use cracked, chipped, warped, or
otherwise damaged discs as they may da-
mage the player.
! Unfinalized CD-R/CD-RW disc playback is
not possible.
! Do not touch the recorded surface of the
discs.
! Store discs in their cases when not in use.
! Avoid leaving discs in excessively hot envir-
onments including under direct sunlight.
! Do not attach labels, write on or apply che-
micals to the surface of the discs.
! To clean a CD, wipe the disc with a soft
cloth outward from the center.
! Condensation may temporarily impair the
player's performance. Leave it to adjust to
the warmer temperature for about one
hour. Also, wipe any dump discs with a soft
cloth.
! Playback of discs may not be possible be-
cause of disc characteristics, disc format,
recorded application, playback environ-
ment, storage conditions, and so on.