Disconnecting A Bluetooth Device; Deleting A Paired Bluetooth Device; Connecting A Paired Bluetooth Device And Selecting A Service - Pioneer SuperTuner IIID DEH-P7100BT Mode D'emploi

Section
08 Using Bluetooth wireless technology
# Push MULTI-CONTROL left or right to display
the device name and BD address.
6 Press MULTI-CONTROL to establish con-
nection.
While connecting, Pairing flashes. If the con-
nection is established, Paired is displayed.
# If the connection fails, ERROR is displayed. In
this case, try again from the beginning.
# PIN code is set to 0000 as the default. You
can change this code in the initial setting. Refer
to Entering PIN code for Bluetooth wireless con-
nection on page 32.

Disconnecting a Bluetooth device

This function can be operated only when the
Bluetooth wireless connection is being estab-
lished.
1 Display the connection menu.
Refer to Introduction to connection operations
on page 28.
2 Use MULTI-CONTROL to select
DisconnectDevice.
3 Push MULTI-CONTROL up or down to
select a device.
# If only one device was found, this step cannot
be performed.
4 Press MULTI-CONTROL to disconnect
the Bluetooth wireless connection.
While disconnecting, Disconnecting flashes.
If the Bluetooth wireless connection is termi-
nated, Disconnected is displayed.
# If multiple Bluetooth devices have been con-
nected and you wish to disconnect them, press
MULTI-CONTROL and then select the device. In
this case, repeat operation from step 3.

Deleting a paired Bluetooth device

1 Display the connection menu.
Refer to Introduction to connection operations
on page 28.
30
En
2 Use MULTI-CONTROL to select
Delete device.
3 Push MULTI-CONTROL up or down to
select a device.
# If only one device was found, this step cannot
be performed.
# Push MULTI-CONTROL left to display the BD
address.
# If device name cannot be obtained, BD ad-
dress is displayed.
4 When the device name is being dis-
played, push MULTI-CONTROL right to dis-
play Delete YES.
Deleting device is now on standby.
# If you do not want to delete the device, push
MULTI-CONTROL left.
5 Press MULTI-CONTROL to delete the de-
vice.
While deleting, Deleting flashes. After the de-
vice is deleted, Deleted is displayed.
Connecting a paired Bluetooth
device and selecting a service
Bluetooth service of the paired device can be
selected. You can choose a Bluetooth service
from PHONE service, AVRCP service or A2DP
service.
1 Display the connection menu.
Refer to Introduction to connection operations
on page 28.
2 Use MULTI-CONTROL to select
Paired device.
3 Push MULTI-CONTROL up or down to
select a device.
# If only one device was found, this step cannot
be performed.
# Push MULTI-CONTROL left or right to switch
the BD address and device name.
# If device name cannot be obtained, BD ad-
dress is displayed.