Initial Setup - Audio-Technica AT-LP60-USB Manuel D'installation Et Utilisation

Initial Setup

Assembling the Turntable
The AT-LP60-USB requires some assembly before first use.
IMPORTANT: Do not connect the AC power cord until assembly is
complete.
1. Carefully place the turntable platter on the center spindle,
making certain the platter is fully seated on the spindle.
2. While holding both ends of the red tape ribbon on the turntable
belt, carefully pull the belt over the brass motor pulley (Fig. 2a).
(If the belt drops off, remove the turntable platter and put the
belt back on it, as described on page 7.)
3. Once the belt is seated in the pulley's groove, carefully remove
the ribbon. Make certain the belt is not twisted.
NOTE: If belt is not correctly positioned around the motor
pulley, the turntable will not operate. Please double-check
to make sure that the belt is positioned correctly.
4. Place the turntable mat on top of the turntable platter (Fig. 2b).
5. If desired, the hinged dust cover may be removed. Hold both
sides of the dust cover and pull upward gently and evenly to
detach the cover from the turntable (Fig. 2c). Keep the cover in
a safe, clean place.
6. To re-install the dust cover, guide the dust cover hinges into
the two hinge receptacles located at the back of the turntable
housing
Connecting to Computers with USB Input
The USB cable (included) connects your AT-LP60-USB turntable to your
computer without need for special drivers. Refer to included software
guide (also available online at www.audio-technica.com) before
connecting the turntable to your computer.
4
Figure 2 – Assembling the turntable
2a – Drive belt
Red ribbon
Drive belt
2b – Record mat
Motor pulley
2c – Dust cover removal
Motor pulley (brass colored)