Makita DUR365U Manuel D'instruction page 14

Attachment of shoulder harness
1
2
► 1. Buckle 2. Hook
Wear the shoulder harness on your left shoulder. Make
sure that the buckle cannot be taken off with pulling it
off. Hang the tool as shown.
1
► 1. Buckle
The buckle is provided with a means of quick release.
Simply squeeze the sides of the buckle to release the
tool.
Adjustment of the hanger position
and shoulder harness
To change the hanger position, loosen the fixing screw
on the hanger with the supplied wrench and then move
the hanger and the cushion. The cushion can be moved
easily by twisting it.
MAINTENANCE
WARNING:
• Always be sure that the tool is switched
off and battery cartridge is removed before
attempting to perform inspection or main-
tenance on the tool. Failure to switch off and
remove the battery cartridge may result in seri-
ous personal injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Replacing the nylon cord
WARNING:
• Use only 2.0 - 3.0 mm (0.08" - 0.12") diameter
nylon cord. Never use metal wire, rope or the
like. Use of something other than the recom-
mended nylon cord may cause damage to the
trimmer and result in serious personal injury.
• Make sure that the cover of the nylon cutting
head is secured to the housing properly as
described below. Failure to properly secure the
cover may cause the nylon cutting head to fly
apart resulting in serious personal injury.
Take off cover from housing, pressing two latches which
are slotted section oppositely on side of housing.
► 1. 80-100 mm (3 - 4 inches)
Cut a nylon line in 3-6m (10 - 20 ft). Fold the cutting line
in two halves, leave one of half longer 80-100 mm (3 - 4
inches) than another.
14 ENGLISH
1