Makita DUR365U Manuel D'instruction page 12

3
► 1. Cutter 2. Clamp 3. Bolt
Align the clamp on the pipe with the protector. And
tighten them with bolts.
Installing the metal blade (optional
accessory)
WARNING:
• The outside diameter of the metal blade must
be 230 mm. Never use any blade exceeding
230 mm in outside diameter.
CAUTION:
• The metal blade must be well polished, free of
cracks or breakage. Polish or replace the metal
blade every three hours of operation.
• Always wear gloves when handling the metal
blade.
• Always attach the blade cover when the tool is
not in use or is being transported.
• The metal blade-fastening nut (with spring
washer) wears out in course of time. If there
appears any wear or deformation on the spring
washer, replace the nut. Ask your local autho-
rized service center to order it.
• Replace the cup in case of crack or breakage
due to attrition.
NOTICE:
• Be sure to use genuine Makita metal blade.
Turn the tool upside down so that you can replace the
metal blade easily.
2
1
► 1. Hex wrench 2. Nut 3. Cup 4. Clamp washer
Mount the metal blade onto the shaft so that the guide
of the receive washer fits in the arbor hole in the metal
blade. Install the clamp washer and secure the metal
blade with the hex nut with 13 to 23 Nm of tightening
torque during holding the receive washer with hex
wrench.
► 1. Hex wrench 2. Box driver 3. Tighten
To dismount the metal blade, insert the hex wrench
through the hole on the protector cover and the gear
case. Rotate the receive washer until it is locked with
the hex wrench. Loosen the hex nut (left-hand thread)
with the socket wrench and remove the nut, clamp
washer and hex wrench.
Make sure that the blade is the left way up.
12 ENGLISH
2
3
4
1
5. Metal blade 6. Receive washer
2
1
5
6
3