Working Procedures; Working With The Clamp; Working With A Tripod - Parkside PKLL 7 A1 Mode D'emploi

Working procedures

■ Use only the centre of the laser line to make your marking.
The width of the laser line changes with the distance.

Working with the clamp

With the help of the clamp
various items, e.g. vertical or horizontal boards or pipes.
♦ Undo the fixing screw
♦ Position the clamp
the fixing screw
♦ Now place the appliance with the tripod thread
screw
tighten the appliance as it could be damaged.
♦ Align the clamp to roughly the position you require before you
switch on the appliance.
♦ To do this, undo the locking screw
to a horizontal position at the desired height.
♦ Retighten the locking screw

Working with a tripod

A tripod offers a stable, height-adjustable support for taking measure-
ments.
♦ Place the measuring tool with the tripod thread
screw of the tripod.
│ GB │ IE
■ 26
you can attach the measuring tool to
.
in the desired location and then retighten
.
and screw it tight with moderate force. Do not over-
and move the appliance
.
on the
on the 1/4"
PKLL 7 A1