Compactor Care; Cleaning Exterior Surfaces - Gladiator COMPACTOR W11034802A Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The drawer is clean and free of debris.

NOTE: An unlatched drawer can cause the drawer monitor
switch to stay open. This will make the ram return and the
compactor will continue to run. Attempt to push the drawer
inwards to stop the compactor. The continuous running of
the compactor can also be attributed to debris in the drawer
area. If it is difficult to open or close the drawer, this may be
due to either the drawer latch not being locked, or debris in
the drawer area.
1. Place folded bag into the drawer. Open bag and pull top
edges over the drawer top.
2. Lock bag in place by pulling the four pre-punched holes
over the bag retainer buttons. Holes will expand over the
buttons without damaging the bag.
3. Press inside of bag against the drawer bottom, sides and
corners for a smooth fit.
Pre-punched holes and bag buttons
NOTE: The ram can and will tear improperly installed bags.

COMPACTOR CARE

Your new compactor is designed to give you many years of
dependable service. However, there are a few things you are
expected to do in order to properly maintain your compactor.
This section will tell you how to clean and care for your
compactor.
NOTE: Any services other than those outlined in this section
should be performed by an authorized service representative.
8
Cleaning
WARNING
Cut Hazard
Wear gloves when cleaning inside the drawer or
cabinet, or the ram.
Failure to do so can result in cuts.
Before cleaning the compactor, open the drawer and turn the
Key-knob to the OFF position and remove it.

Cleaning Exterior Surfaces

1. Wash exterior surfaces (including stainless steel) with a clean
sponge or soft cloth and a mild detergent in warm water. Do
not use abrasive or harsh cleaners. Rinse and dry thoroughly
with a soft cloth.
2. Wipe up spills immediately. Some foods can damage the
finish if left on the compactor surface.
Cleaning Inside the Drawer
1. Pull drawer out until it stops.
2. Remove the bag. See the "Removing a Filled Bag" section.
3. Optional: Remove the drawer side.
Hold the drawer latch open and tilt the side of the drawer
out until the latch clears the drawer front.
Remove the drawer side by lifting it out of the drawer.
4. Wash the interior of the drawer with a clean sponge or soft
cloth and a mild detergent in warm water. Rinse and dry
thoroughly with a soft cloth.

Publicité

Table des Matières
loading

Table des Matières