Installation Instructions - Gladiator COMPACTOR W11034802A Instructions D'utilisation

Installer: Leave User Instructions with the homeowner.
Homeowner: Keep User Instructions for future reference
and for local electrical inspector's use if required.
Tools needed
Gather the required tools and parts before starting installation:
Level
Tape measure
Pliers
Scissors
Parts Supplied
Screws / -20" X / " (16)
1 3
4 4
Nuts / -20" (16)
1
4
Unpacking
WARNING
Excessive Weight Hazard
Use two or more people to move and install compactor.
Failure to do so can result in back or other injury.
IMPORTANT: Do not grasp control panel to move the compactor.
Begin in the room where the compactor will be located.
1. Remove compactor from shipping carton. Follow the
instructions on the shipping carton.
2. Remove all packaging materials, such as tape and
shipping pads.
3. Use a mild detergent and warm water to remove waxy
residue caused by shipping material.
4. Dry thoroughly with a soft cloth. For more information,
see "Cleaning" in the "Compactor Use" section.
5. Be sure the power cord is attached to the cord clip on
the rear of the compactor.
Power cord clip
6. Place two of the four corner posts from the packaging on the
floor near the compactor.
7. Press the foot pedal or use the handle to open the
compactor drawer and remove any shipping materials or
other items from the drawer.
NOTE: Do not remove the compactor bag.
4

INSTALLATION INSTRUCTIONS

Tools
Phillips No. 2 screwdriver
Flat-head screwdriver
/ " box-end wrench
5
16
Utility knife
8. Grasp the front of the drawer and tilt it backwards slightly
while pulling forward to clear the drawer stops.
9. Grasp the drawer handle or sides of drawer and lift drawer
out of compactor.
10. Place the drawer on the two corner posts.
11. Place the other two corner posts on the floor to the side
of the compactor.
12. Grasp the sides of the compactor cabinet and place
compactor on its side on top of the second set of corner
posts.
13. Remove the shipping base from the bottom of
the compactor.
Leveling legs
Shipping base
Corner posts