Gladiator COMPACTOR W11034802A Instructions D'utilisation page 5

Install the Casters
(optional)
IMPORTANT:
Do not grasp control panel to move compactor.
Slide compactor onto cardboard or hardboard before moving
compactor across floor to prevent damaging floor covering.
Do not allow the rear frame of the compactor to touch the
floor covering when lifting or moving compactor.
Assemble Caster Frame
1. Locate included caster frame. Set it on the floor with the lip
facing down.
C
A. Caster frame
B. Closed end of caster frame (with lip)
C. Open end of caster frame (without lip)
2. Install the (2) swivel casters to the back (closed end) of the
frame assembly with (4) bolts and nuts.
3. Install the (2) fixed casters to the front (open end) of the
frame assembly with (4) bolts and nuts.
D
A. Swivel casters
B. Fixed casters
A
B
A
B
C
C. Open end of frame assembly
D. Closed end of frame
assembly
Install Compactor On Caster Frame
1. To keep the caster frame from moving during the initial
installation, block the wheels or place frame against a wall.
2. Lock the back casters in place by pushing the locks down.
3. Tilt the back of the compactor forward and push the
compactor up onto the caster frame assembly over the open
end of the frame.
4. Slide the compactor all the way back until it touches the
back lip of the caster frame assembly.
Install the Compactor
IMPORTANT: Do not grasp control panel to move compactor.
1. Move the compactor to its final position.
2. Grasp sides of compactor drawer and place bottom of
drawer into tracks.
3. Lift at the handle so drawer will go over drawer stops.
4. Close the drawer.
5. Check that drawer opens freely. If the toe plate rubs against
floor, see "Adjusting the Toe Plate" for further instructions.
6. Plug into a grounded 3 prong outlet.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate clearance
may be changed as follows:
1. Mark on each side of the toe plate the amount of toe plate
that rubs the floor covering.
2. Remove the drawer from the unit. See Step 3 in the
"Unpacking" section.
3. Use a ruler and a pencil or chalk to draw a line between the
marks on each side of toe plate.
4. Use scissors or utility knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering, repeat
steps 1 through 4.
Adjusting the Toe Guard
If the toe guard rubs the floor covering, the toe guard clearance
may be changed as follows:
1. Mark on each side of the toe guard the amount of toe guard
that rubs the floor covering.
Wall
5