Memorising The 2- Or 4-Button Remote Control For Pedestrian Opening - Fig; Clearing The Remote Controls And All Settings; Clearing The Settings - Fig; Clearing The Memorised Remote Controls - Fig - SOMFY ELIXO 2000 230v rts Manuel D'installation

EN
7.3. Memorising the 2- or 4-button remote controls
for pedestrian opening - Fig. 21
1) Press the PROG button on the control unit for 2 seconds.
The indicator light is lit constantly.
2) Press the PROG button a second time.
The indicator light flashes once slowly.
3) Press the button of the remote control that will open the gate for pe-
destrians.
The indicator light flashes; the remote control has been stored.
8. CLEARING THE REMOTE CONTROLS
AND ALL SETTINGS

8.1. Clearing the settings - Fig. 22

Attention
If the settings are deleted, they are reset to the factory values. It
is important to set the gate opening direction again and to conduct
auto-programming again.
1) Select in the control unit menu.
2) Press OK on the control unit to confirm the factory configuration reset
of the control unit.

8.2. Clearing the memorised remote controls - Fig 23

Press the PROG button on the control unit for 7 seconds.
The indicator light flashes slowly; all remote controls have been cleared.

9. DIAGNOSTIC AND TROUBLESHOOTING

9.1. Diagnostics

Code Description
Activation of the external
radio start input
Activation of the OPEN
input
Activation of the CLOSE
input
Activation of PED input
Activation of the STOP
input
Activation of photoelectric
cells input active when
opening
Activation of photoelectric
cells input active when
closing
Activation of safety edge
input
Activation of the motor
closing end limit input
Activation of the motor
opening end limit input
Auto-programming in
progress
Safety edge autotest
failure
Autotest failure of photo-
electric cells active when
opening
9
Comments
Check connection and/or settings.
Check connection and/or settings.
Code Description
Autotest failure of photo-
electric cells active when
closing
* Circuit board equipment
test error
* Obstacle detection
* System supervision inter-
nal control error
* = 0, 1, ....., 9, A, B, C, D, E, F

10. TECHNICAL DATA

Power supply 220-230 Vac 50/60 Hz
Power consumption 750 W
Maximum torque 40 Nm
Speed 9 m/min
Maximum gate leaf 2000 kg
weight
Maximum gate leaf length 20 m
Lubrication ERGOIL oil bath
Manual manoeuvring Release using individual key
Climatic operating con- - 20°C/+ 55°C - IP 24
ditions
Noise level < 70 dBA
Radio frequency
Number of storable 32
channels
ELIXO 2000 230V RTS
Comments
Check connection and/or settings.
Check connections on the motor.
Equipment problems on the
circuit board; contact Somfy.
Check the presence of an
obstacle.
Try to switch the circuit board
off and on again. If the problem
persists, contact Somfy.
433.42 MHz
< 10 mW
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.