Intended Use - Forch 5350 9011 Mode D'emploi

■
All safety, warning and operating instructions on the device have to be kept in a well-legible
state.
■ Damaged signs or labels should be replaced immediately.
■
Specified settings or areas have to be strictly observed.

2.2. Intended use

Operational safety is guaranteed only when used as intended in accordance with the corre-
sponding information in the operation manuals, the operating instructions and taking into ac-
count the safety regulations. Use and maintenance have to be always in accordance with your
local state or federal regulations.
■ Only operate device in technically faultless and reliable condition.
■
Make sure that safety equipment is always freely accessible and regularly controlled.
■
The intended use of the corresponding pneumatic tool is defined in its operation manuals
resp. its operating instructions.
■
The improper use of the FÖRCH-pneumatic tool or use which cannot comply with the safety
regulations can result in serious injury or death.
■ Any deviation from the intended use beyond and/or different use of the device is forbidden
and considered to be improper.
■
Claims of any kind against the manufacturer and/or its agent from damage by improper use
of the device are excluded.
■
The operator is liable for all damages resulting from improper use.
2.3. Hazard emanating from the device
Before each use the FÖRCH-tool has to be controlled for full functionality. If the functional-
ity cannot be guaranteed according to the result of this examination or if further damages are
found, the unit must not be used. If full functionality is not given and the unit is used neverthe-
less, there is the danger of serious body injuries, damages to someone's health or property
damages.
■
Devices where the ON/OFF-switch is damaged, must not be used.
■ Tools that cannot be switched on or off with the ON/OFF-switch anymore are dangerous and
have to be repaired.
■
All service and repair works have to be carried out by qualified personnel.
■ To ensure long term operational safety, only original spare parts are to be used.
■
Protective equipment and/or body parts may not be removed.
■
Never operate the tool when a protective cover is missing or when not all safety equipment is
present and in perfect condition.
■
For safety reasons modifications on FÖRCH-tools are prohibited. Any modifications ex-
ecuted at the device result in immediate exclusion of any liability.
■ During operation vibrations from the device are transmitted tot the operator. Absolutely wear
safety gloves.