Fit The Pedals; Adjust The Saddle - Youin BK2026B Manuel De L'utilisateur

Instructions for use

Fit the pedals

Screw the pedals to the cranks: the RIGHT
pedal is marked on the pin by a letter "R";
screw this pedal clockwise on the RIGHT
crank (chain side). The LEFT pedal is marked,
on the pin, by a letter "L"; screw this pedal
anticlockwise on the LEFT crank arm (Pic. 7).
Initially screw the pedals with your hands,
then tighten with the wrench until, without
forcing too much, you reach the end of the
stroke.
WARNING: scrupulously follow the instructions to avoid damaging the threads of the
pedal and / or crank. If you notice any anomaly in the movement of the pedal during
use, immediately stop pedaling and have the bicycle checked by a mechanic.

Adjust the saddle

The correct adjustment of the saddle is important for the position of the body while
pedaling and allows you to obtain the best performance with less stress on the joints.
Before use, ride the bicycle and adjust the height and angle of the saddle.
Height
The height of the saddle must be adjusted according to the length of the legs. The
height is correct if, while sitting, you reach the pedal placed in the lowest position
with the heel. The leg must be completely straight. Adjust the height according to
these indications.
In the height adjustment, in any case respect the STOP MARK on the seat post.
THE NOTCH MUST ALWAYS BE INSERTED IN THE FRAME TUBE (Photo 8).
Angle
In case you want to keep the saddle not completely horizontal but with the "nose"
slightly raised, you must loosen the locking placed under the saddle and adjust the
angle. Re-tighten the lock so as not to move the saddle.
Changes in the position of the saddle, even if small, can affect comfort while pedaling.
It is recommended, each time you want to make an adjustment, to make only one
change at a time and gradually until you find the most comfortable and correct
position.
(Pic. 7)
Anticlockwise
Clockwise
ENGLISH 9