Hailo M80 Mode D'emploi page 20

5. Assembly / operation
5.2 Adjusting for the step or single ladder
Using the hinge joint [C], the ladder is converted into
either a stepladder or single ladder.
The foldable ladder part [B] is first unlocked and – af-
ter the ladder has been brought into the desired set-up
position – locked again.
For adjusting one of the ladder parts, both of the
safety joints on opposite sides of the ladder have to be
activated.
Item no. 7512-xxx, 7516-xxx, 7520-xxx
1. Original position: the ladder is locked, and the stop
button [C-2] is in the
2. Pull up the lever [C-1], and the ladder is unlocked.
The stop button [C-2] is in the
The ladder part [B] can now be adjusted to the
desired position.
3. The ladder part [B] audibly clicks into place auto-
matically. The ladder is locked, and the stop button
[C-2] is in the position.
This procedure is repeated once again to bring it into
another set-up position.
Item no. 7524-xxx
1. Original position: the ladder is locked, and the clamp
[C-3] is pushed in.
2. Pull out the clamp [C-3] and place it on the safety
joint by turning it slightly.
The locking opening is free, the ladder is unlocked
and the ladder part [B] can now be adjusted into the
desired position.
3. The ladder part [B] audibly clicks into place auto-
matically. The ladder is locked, and the clamp [C-3] is
pushed in.
20
position.
position.
Item no. 7512-xxx
5.2
Item no. 7516-xxx
Item no. 7520-xxx
Item no. 7524-xxx